![]() Now works great! Hardest part was manipulating the dabbing of the epoxy on the spline due to working with mirror image. Waited until next morning to try printer. Very carefully slid the gear with fingers back on the shaft spline viewing that it was centered on the mating gear. Mixed some two part epoxy and carefully dabbed small amount on the shaft spline until about 100% coated. Then slid the gear down & off the spline. (can move the gear by hand back in line with the gear train and try once to see if it fixes problem). One small plastic gear slid off the steel shaft 'spline' not engaging drive train. ![]() Taped drop light to now top of printer looking at the mirror/gear train. Positioned small flat mirror angled on its edge to view gear train. Let me know the outcome.Stood hp 310a on its side. ![]() I came across your post and would like to help. All the for reaching out to us on HP Support Forums. Hot Water Printhead Flush - HP Ink Series Printers with removable Printhead. If the issue persists, take a look at this video, you might find it very helpful. If the issue still persists, I suggest using the following document to troubleshoot the issue. Once the alignment is complete, then the ink system reset/reinitialization is complete.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |